AC Load

The PEL Regenerative Electronic AC Load is ideal for testing AC power generators, primarily motor generators, turbine generators, frequency converters and power inverters. This AC load series is the smart alternative to the resistive loads typically used in these environments. The PELs transfer energy that would naturally be lost to heat, back to the grid, reducing energy cost and lowering the cost of ownership. The PEL series also provides accurate performance measurements for the unit under test for all phases of test from engineering development, system evaluation, compliance testing and manufacturing tests including burn-in.

Key Features

  • Flexible test for single phase and 3 phase test unit
  • 60kVA to 2MVA models
  • Energy feed back to the utility grid with 90% efficiency
  • Power factor control
  • Parallel connected for future capacity expansion

Featured Benefits

  • Support single and three phase EUTs
  • Independent phase control
  • Regenerates up to >90% of energy to the grid
  • Applied dig.synchronization technology with 0.98 utility powerfactor
  • Selectable CC, CR, CP and Power factor load control
  • Load profile transient generation
  • Built in power measurement system
  • Independent phase control
  • Low input and output distortion
  • Compact design that minimizes floor space requirements
  • Integrated high accuracy measurements
  • 7 touch panel interface
  • Modbus RS485 and LAN Ethernet remote interfaces
PEL-33060

PEL-33060 techn.inf.